82357b Driver Windows 10 ((free)) (Authentic 2024)

If after all steps your 82357b still doesn’t work on Windows 10, check these final points:

from your taskbar. The 82357B should appear in the interface list, ready for instrument communication. 4. Special Case: Using with NI-VISA If your existing software (like LabVIEW) requires National Instruments (NI) VISA instead of Keysight's: Install the In Keysight Connection Expert, go to 488 Programs and check the box for "Enable Keysight GPIB cards for 488 programs" In NI MAX (Measurement & Automation Explorer), enable the Tulip Passport 82357b driver windows 10

Need further help? Check out the EEVblog forums (section: Test Equipment) or the Keysight Support Community where engineers actively discuss 82357B workarounds for the latest Windows updates. If after all steps your 82357b still doesn’t

Yes – the Prologix USB-GPIB controller or AR488 (open source). Both have native Windows 10 signed drivers and are easier to set up. Special Case: Using with NI-VISA If your existing

Yes, but only with the NI-VISA bridge method and test mode enabled. As of 2025, no signed 64-bit driver exists for the latest Windows 10 builds.

| Error Code | Description | Windows 10 Fix | |------------|-------------|----------------| | | Device cannot start | Usually a driver signing issue. Reboot with signature enforcement disabled. | | Code 31 | Driver is incorrectly installed | Use the Manual Driver Update method and force the specific INF from NI-VISA. | | Code 52 | Driver not digitally signed | Permanently enable Test Mode: bcdedit /set testsigning on and reboot. | | Code 43 | USB device reset failed | Try a different USB port (USB 2.0 port, not 3.0). Use a powered USB hub. |