False. DIN 7160 applies only to center distances between shafts and holes. Do not use it for edge distances or slot lengths.
It is crucial to note that modern engineering has largely moved toward international standardization. Today, has effectively superseded the older DIN 7160. However, the terminology and specific tolerance values found in DIN 7160 remain deeply embedded in European manufacturing legacy drawings, technical documentation, and machinery maintenance. Understanding DIN 7160 is therefore essential for engineers working with: din 7160 tolerance
) for various shaft tolerance zones. These values are used to determine the exact upper and lower limits of a shaft's diameter based on the desired fit (clearance, transition, or interference). Clearance Fits: e8, f7, g6, h6, h7, h8, h9. Transition Fits: j6, js7, k6, n6. Interference Fits: p6, r6, s6, u8. Example Tolerance Values (h6 Shaft) DIN 7160 - 1965-08 It is crucial to note that modern engineering
If you want to invoke DIN 7160 on a technical drawing, you should add a note in the title block or general tolerance block: Understanding DIN 7160 is therefore essential for engineers
While the original DIN 7160 defined specific tables, modern interpretation uses the following standard tolerance classes for center distances, often denoted by "CD" (Center Distance) on drawings.