Navigate to → "Customize Buttons" . Define a button named "Get ID" with:
SSCOM 3.2 is a serial port debugging assistant used primarily by engineers and hobbyists to send and receive data over a COM port. Unlike a standard terminal emulator, it is specifically designed for technical tasks like sending , monitoring hex data, and verifying hardware responses in real-time. Key Features and Capabilities sscom 3.2
If you've found an "interesting write‑up" about it, here’s what makes SSCOM 3.2 noteworthy: Navigate to → "Customize Buttons"
Now, clicking that button sends the command and waits for OK before notifying you. Key Features and Capabilities If you've found an
| Problem | Likely Cause | Solution | | :--- | :--- | :--- | | Cannot open COM port | Port already in use | Close Arduino IDE or other serial monitors. | | Data received is gibberish | Baud rate mismatch | Try 9600, 19200, 57600, 115200. Also check data bits (7 vs 8). | | SSCOM crashes on send | Large file with zero delay | Increase inter-frame delay to 10-20ms. | | No data received | TX/RX crossed | Swap RX and TX wires. Ground must be common. | | Chinese characters in UI | System locale | Use English version (SSCOM32E.exe) or set non-UNICODE program language to English. |