Pax-ii 800 Manual - -

: Programming menus for Limits (P1), Force (P2), and Photo Beams (P3). Maintenance Tip:

: Upon plugging in, the LED display typically cycles through numbers (99 to 11) before entering a standby state, indicated by "- -". Setting Limits (The "Learn Run") : Press and hold the SET button until the display shows "P1". Pax-ii 800 Manual -

When you unbox your Pax, the LED indicator on the front will likely blink yellow or red. Plug the proprietary magnetic USB charger into the side of the device. The LED petals will pulse white while charging. When the light turns solid green, the device is fully charged. : Programming menus for Limits (P1), Force (P2),

| Error Code | Meaning | Solution from Manual | |------------|---------|----------------------| | | Overload (weight exceeds max capacity + 2%) | Remove weight immediately. Check for mechanical binding. | | Err 02 | Underload (negative weight or missing load cell connection) | Ensure pan is seated correctly. Power cycle. | | Err 05 | A/D converter failure | Internal fault. Contact service. Manual lists warranty conditions. | | Err 08 | EEPROM checksum error | Settings corrupted. Enter setup menu to restore defaults (see page 34). | | Lo Bat | Low battery (if battery option installed) | Recharge for 8 hours. Replace with recommended 6V 4.5Ah SLA battery. | | --- (flashing) | Reading unstable | Check for vibrations, drafts, or magnetic fields. Re-zero. | When you unbox your Pax, the LED indicator

Finding the right manual for your garage door system can be a challenge, especially with a versatile workhorse like the Pax-II 800