I--- Mcgs Hmi Touch Calibration

Whether you are using an older TPC series model or a modern McgsPro panel, touch misalignment is inevitable over time. Factors like electrostatic interference, temperature fluctuations, physical wear, or even a firmware glitch can cause the digitizer to lose sync with the LCD display. Without proper calibration, your HMI becomes a liability—slowing down production and creating safety hazards.

In these cases, replacement is the only fix. MCGS offers replacement touch panels for most models (TPC, TPS, and TPi series). Order the correct digitizer kit and carefully replace it, or send the unit to an authorized service center. After replacement, always perform a fresh calibration. i--- Mcgs Hmi Touch Calibration

Even with the right steps, can fail. Here is how to fix the most frequent issues: Whether you are using an older TPC series

You tap all five crosshairs, but the calibration restarts immediately. Cause: The calibration data is not writing to the registry, or the touch controller is sending “noise.” Solution: In these cases, replacement is the only fix