Mtc Pronest 8.02.01 -
Cut parts are 1mm undersize. Cause: Version 8.02.01 has a known quirk where legacy posts ignore "Left/Right" compensation if the part has nested holes. Fix: In the post editor, unlock the "Compensation" tab and check the box for "Apply separate wear for internal contours."
Tip: Using is often recommended for physical cutting as they typically require fewer "tabs" to keep the center of letters from falling out. MTC Pronest 8.02.01
If you are still running Pronest 7.x, the jump to 8.02.01 is substantial. Cut parts are 1mm undersize
The 8.0 series was a major architectural overhaul from previous versions, introducing a more modern user interface and 64-bit processing capabilities. was one of the most stable and widely adopted iterations of this new architecture. If you are still running Pronest 7
Let’s walk through a standard job in MTC Pronest 8.02.01.