KPG-89D is Kenwood’s proprietary Windows-based application. It allows you to set frequencies (within the radio’s VHF range, typically 136–174 MHz), squelch types (CTCSS/DCS), power levels (high/low), scan lists, and numerous advanced features like lone worker, emergency signals, and signalling protocols (FleetSync, MDC-1200, or 2-Tone). Without this software, the TK-3170 is essentially a brick—it cannot be field-programmed from the keypad.
| Error Message | Likely Cause | Solution | |---------------|--------------|----------| | "Model Mismatch" | The software expects a different radio model (e.g., TK-3170 vs TK-3173). | Reinstall KPG-89D and ensure you selected "TK-3170" at startup. | | "Checksum Error" | Corrupted codeplug or interrupted write. | Re-read the radio, make a small change, and write again. | | "Communication Timeout" | Wrong COM port or cable driver issue. | Reinstall cable driver, try COM1–COM4 manually. | | "Password Protected" | The previous programmer locked the radio. | You need the master password (contact the previous owner) or use brute-force tools (not recommended). | kenwood tk-3170 programming software
Using the Kenwood TK-3170 programming software is relatively straightforward. Here's a step-by-step guide to get started: KPG-89D is Kenwood’s proprietary Windows-based application
KPG-89D is Kenwood’s proprietary Windows-based application. It allows you to set frequencies (within the radio’s VHF range, typically 136–174 MHz), squelch types (CTCSS/DCS), power levels (high/low), scan lists, and numerous advanced features like lone worker, emergency signals, and signalling protocols (FleetSync, MDC-1200, or 2-Tone). Without this software, the TK-3170 is essentially a brick—it cannot be field-programmed from the keypad.
| Error Message | Likely Cause | Solution | |---------------|--------------|----------| | "Model Mismatch" | The software expects a different radio model (e.g., TK-3170 vs TK-3173). | Reinstall KPG-89D and ensure you selected "TK-3170" at startup. | | "Checksum Error" | Corrupted codeplug or interrupted write. | Re-read the radio, make a small change, and write again. | | "Communication Timeout" | Wrong COM port or cable driver issue. | Reinstall cable driver, try COM1–COM4 manually. | | "Password Protected" | The previous programmer locked the radio. | You need the master password (contact the previous owner) or use brute-force tools (not recommended). |
Using the Kenwood TK-3170 programming software is relatively straightforward. Here's a step-by-step guide to get started: